How to configure SPAN and RSPAN in Cisco Catalyst switches

Switched Port Analyzer (SPAN) allows you to send a copy of traffic passing through ports to another port on the switch. SPAN is important to mirror received or transmitted (or both) traffic on one or more source ports to a destination port for analysis. While SPAN is mirroring ports in the same switch, RSPAN(Remote SPAN) is mirroring ports in one switch to a port in different switch.

This post describes how to configure SPAN and RSPAN on Cisco Catalyst switches. On this example I use Cisco 2970.

1. SPAN

See the figure below, you would like to monitor the incoming traffic on port Gi0/1 using Wireshark connected to port Gi0/2.

 

Here is the config you should have in the Switch

Switch#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch(config)#monitor session 1 source interface Gi0/1 rx
Switch(config)#monitor session 1 destination interface Gi0/2
Switch(config)#end

Incoming traffic passing through port Gi0/1 will be mirrored to port Gi0/2 and captured by Wireshark on Laptop connectedd to port Gi0/2.

2. RSPAN (Remote SPAN)

See the image below for sample topology. You would like to monitor traffic on port Gi0/1 in Switch1 using a Laptop connected to port Gi0/2 in Switch2. Both switches must be able to run RSPAN to work properly.

Create a VLAN that will be used as an RSPAN-VLAN on both switches. On this example we use vlan id 30 as the RSPAN-VLAN. Then allow the RSPAN-VLAN on the trunk port between Switch1 and Switch2.

 

Here is the config you should have:

Switch1 (Source switch)

Switch1#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch1(config)#vlan 30
Switch1(config-vlan)#name RSPAN-Vlan
Switch1(config-vlan)#remote-span
Switch1(config-vlan)#exit
Switch1(config)#monitor session 1 source interface Gi0/1 rx
Switch1(config)#monitor session 1 destination remote vlan 30 
Switch1(config)#end

Allow vlan id 30 on the trunk port Gi0/2

Switch1#sh run int g0/2
Building configuration...

Current configuration : 175 bytes
!
interface GigabitEthernet0/2
 description To-Switch2-port-Gi0/1
 switchport trunk encapsulation dot1q
 switchport trunk allowed vlan 10,20,30
 switchport mode trunk
end

Switch2 (destination switch)

Switch2#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch2(config)#vlan 30
Switch2(config-vlan)#name RSPAN-Vlan
Switch2(config-vlan)#remote-span
Switch2(config-vlan)#exit
Switch2(config)#monitor session 1 destination interface Gi0/2
Switch2(config)#monitor session 1 source remote vlan 30 
Switch2(config)#end

Allow vlan id 30 on the trunk port Gi0/1

Switch2#sh run int g0/1
Building configuration...

Current configuration : 175 bytes
!
interface GigabitEthernet0/1
 description To-Switch1-port-Gi0/2
 switchport trunk encapsulation dot1q
 switchport trunk allowed vlan 10,20,30
 switchport mode trunk
end

With the config above, incoming traffic passing through port Gi0/1 on Switch1 will be mirrored to port Gi0/2 onSwitch2 and captured by a traffic analyzer on Laptop connected to port Gi0/2.